SOLUPROD

SOLUPROD
SOLUPROD - Image 2
Agronomic interests
Supply combined with Nitrogen, Phosphorus, and Potassium, essential to the good progress of the crop. The proportion of each element is specific to the needs of the plant then allowing an improvement of the overall nutritional status of the plant
SOLUPROD is a polyvalent product which is suitable to numerous crops.
It is specifically adapted to nutrition, improvment and growth of the vegetative system.a
This product is formulated with rigorously selected raw materials, guaranteed by quality control, to ensure a perfect safety of use and to optimize the absorption through the leaves
Directions of use

FOLIAR APPLICATIONS

ALL CROPS – Rate : 1-5 kg/ha – Maxmium Concentration: 5%
Timing : 2-3 applications on well-developed foliage

SOIL Application

By hydroponics 0.05 – 0.2% solution (0.5 – 2Kg / 1000 l of water)
In open field 0.1 – 0.2% (1-2Kg / 1000 l of water)
In Fertigation 7.5 – 10 Kg/ha (3 -5 applications)

The mentioned indicated dosages are given as a guideline. Exact dosages, concentration and application stage are subject to local conditions, use of other fertilizers and can only be given after an objective diagnosis.

For best results, use sufficient water to achieve an even crop coverage to the point of run-off. Avoid spraying in very strong sunlight and/ or very high temperatures. If possible, apply during evening or early morning especially if day-time temperatures exceed 28°C. Very young foliage and crops under stress may be more susceptible to scorch. Lower doses should be applied in these circumstances and the application interval reduced accordingly. Refer to the Crop Recommendations table for application rates and timings for individual crops.

MIXING

Fill the spray tank with half the required amount of water and start agitation. Shake container well and add the required amount of our product, then add the rest of the water maintaining agitation continuously. After spraying, clean and rinse the spraying equipment thoroughly. When combining with other components in a tank-mix, always add this product last. If there is any doubt at all, consult the manufacturer or distributor concerned.